Peavey Headliner, Operating Manual

Page: 7 / 13

18
EXTERNAL SPEAKER OUTPUT
One 2-pin twist-lock powered speaker output, paralleled with 1/4" powered speaker output (20).
1/4" EXTERNAL SPEAKER OUTPUT
1/4" powered speaker output, paralleled with 2-pin twist-lock powered output (19).
FOOTSWITCH JACK
Plug your Headliner footswitch into this 1/4" jack. The footswitch controls the crunch effect and
the compressor on/off. NOTE: The crunch and compressor buttons MUST be engaged to operate
with the footswitch. The part number for the TNT/Headliner footswitch is 03008010.
EFFECTS LOOP
The Send Jack provides a preamp output that may be used to drive slave amplifiers and external ef-
fects processors. The Return Jack provides a power amp input for the last effect in the chain. NOTE:
When using the unit as a slave power amplifier, the Return Jack should be used as the input.
DIRECT INTERFACE (DI)
This built-in, balanced Direct Interface is used to send a buffered, signal to an external mixer.
DI PRE/POST SWITCH
This button toggles the DI output from pre EQ to post EQ.
GROUND LIFT
This button is provided to prevent a ground loop that may result in "hum" noise. When depressed
(IN position), Ground Lift is engaged.
19
20
21
22
23
24
25
Tour Series Headliner Head Block Diagram
Meridian, MS 39301
Peavey Electronics Corp.
P. O. Box 2898
Sheet Title:
Title:
Sheet Date: of
4
3
2
1
D C B A
A B C
1
2
3
4
D
B
NOTCH
EQ
LO HI
Graphic EQ
HI PASS
HI PASS
LO PASS
2
1
SHELVING EQ
CONTOUR
PAD
INPUT
BRIGHT
PRE GAIN
POWER AMPLIFIER
STEREO HEADPHONE JACK
HEADPHONE AMPLIFIER
POST GAIN
FX SEND
FX RETURN
GROUND LIFT
COMPRESSOR
CRUNCH CIRCUIT
HEADLINER FUNCTIONAL BLOCK DIAGRAM
SPEAKER OUTPUTS
BALANCED DI
PRE/POST EQ
2
3
4
1
HEADLINER_BLOCK
2-18-2010_17:02 1 1