Peavey D Series, Hardware Manual, Page: 15 / 32

D Series Hardware Manual
July 7, 2017 Version 2.0.0.0 11
on specific audio functions, such as a mute, or in conjunction with level
controls, switches and simple audio routing.
Trigger mode In trigger mode, each button transmits a momentary signal when
pressed. This signal is a one-shot command that the software recognizes
as a trigger. A trigger has no on or off state, it is simply a momentary
logic signal. When a trigger has been activated, the button LED will
illuminate and stay illuminated until another trigger in the same group is
activated. The buttons work in the same way as radio buttons in a
software application. They can be used as preset selectors in all
products, and additionally, as a router (source select) control, in some
products. Refer to the product manuals for more information.
Note: If the LEDs start flashing, this means no NWare D series device in the NWare project
has been assigned the device ID set on the physical device.
4. Mounting Bracket Single-gang (1G) mounting bracket for installation into standard
NEMA 1G switch box.
5. DIP Switch Eight individual switches that assign button mode (switch 1), device ID
(switches 3-7) and EOL termination function (switch 8). Switch 2 is reserved.
6. RJ-45 Connectors Dual RJ-45 connectors for installation into D Series RS-485 network.
These connectors are wired in parallel and include data and power supply connections.
The recommended cable is UTP Category 5 (CAT5) or better.