Peavey Architectural Acoustics AAM 2443, User Manual

Page: 12 / 20

B BU US SE ES S -- The signal paths through the mixer from the channels to the various outputs. The AAM
™
2443/3243 mixer contains 13 different buses: L, R, MONO, SUBS 1-4, AUX 1-6.
S SU UB B g grro ou up pss -- The buses used to group channels together. This allows one fader to control a submix
of many channels.
A AU UX X sse en nd dss -- The buses used to route signals to effects and monitors from each channel. PRE means
AUX level is not affected by fader setting; POST means AUX level is affected by fader setting.
P PFFLL -- PRE-FADER LISTEN. PFLs send signals to the headphone output before master fader setting
and are not affected by the fader setting.
A AFFLL -- AFTER-FADER LISTEN. AFLs send signals to the headphone output after master fader setting
and are affected by the fader setting.
LLO OW W C CU UT T -- (channel low cut). These adjust the frequency in the channel where the low frequencies
begin to roll off, and are variable by frequency from OFF (inaudible) to 300 Hz.
11//2 2,, 3 3//4 4,, LL//R R,, M MO ON NO O -- These buttons route the channels to their respective output buses. BAL/PAN
determines 1/2, 3/4 or L/R.
IIN NS SE ER RT TS S -- These jacks allow the signal to be taken from and returned to the channel, allowing
outboard equipment to be inserted into the signal chain.
M MIID D FFR RE EQ Q -- This control selects the frequency adjusted by the MID control in the EQ section.
C CO OM MP PR RE ES SS SO OR RS S -- These reduce levels at a ratio of 4 to 1 when the THRESHOLD is reached.
T TH HR RE ES SH HO OLLD D -- This control sets the level at which compression activates.
G GA AIIN N -- This control sets the output level from the compressor. This is really a makeup gain, allowing
the user to recover gain lost by compression.
LLIIN NK K -- When these buttons are depressed, the input to compressor 1 activates compressors 1 and 2,
and the input to compressor 3 activates compressors 3 and 4.
S SU UB BG GR RO OU UP P//E EX XT TE ER RN NA ALL -- This button routes the compressor signal to the compressor output jack
(LED indicates external jack). This jack is wired reverse of an insert jack, allowing the compressor to
be patched with a 1/4" TRS cable.
P PH HA AN NT TO OM M P PO OW WE ER R -- Pr48 Volt power to microphones that need it.
12
G Gllo ossssa arryy
All manuals and user guides at all-guides.com