electric mixer 120ltr 1400w/110v
model no:
Pm120l110v
thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. Safety
1.1.
electrical Safety
warNiNG!
It is the responsibility of the owner and the operator to read, understand and comply with the following:
You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets and
any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the installation of appropriate
safety devices. A Residual Current Circuit Breaker (RCCB) should be incorporated in the main distribution board. We also recommend
that a Residual Current device (RCd) is used. It is particularly important to use an RCd with portable products that are plugged into a
supply which is not protected by an RCCB. If in any doubt consult a qualified electrician. You may obtain a Residual Current device by
contacting your Sealey stockist.
9
You must also read and understand the following instructions concerning electrical
safety.
1.1.1.
The
electricity at work act 1989
requires that all portable electrical appliances, if
used on business premises, are tested by a qualified electrician, using a Portable
ApplianceTester (PAT), at least once a year.
1.1.2.
The
Health & Safety at work act 1974
makes owners of electrical appliances
responsible for the safe condition of those appliances and the safety of the appliance
operators. If in any doubt about electrical safety, contact a qualified electrician.
9
ensure that the insulation on all cables and on the appliance is safe before connecting
it to the power supply.
9
ensure that cables are always protected against short circuit and overload.
9
Regularly inspect power supply cables and plugs for wear or damage and check all
connections to ensure that none are loose.
9
ensure that the voltage marked on the appliance matches the power supply to
be used.
8
DO NOt
pull or carry the appliance by its power supply lead.
8
DO NOt
pull the plug from the socket by the power cable.
8
DO NOt
use worn or damaged cables, plugs or connectors. Immediately have any
faulty item repaired or replaced by a qualified electrician.
9
ensure the unit is correctly earthed via a three-pin 110V plug.
a) Connect the gReen/YelloW earth wire to the earth terminal ‘Pe’.
b) Connect the BRoWn live wire to the live terminal ‘l/+’.
c) Connect the Blue neutral wire to the neutral terminal.
d) After wiring, check that there are no bare wires, that all wires have been correctly connected, that the cable outer insulation extends
past the cable restraint and that the restraint is tight.
1.2.
GeNeral Safety
9
disconnect the mixer from the mains power before changing accessories, servicing or performing any maintenance.
9
maintain mixer in good condition. Check moving parts and alignment of mixing paddle. If necessary use an authorised service
agent.
9
Replace or repair damaged parts. use recommended parts only. unauthorised parts may be dangerous and will invalidate the warranty.
9
Wear approved safety eye protection and a dust mask if mixing generates dust. Rubber gloves are recommended.
9
Remove ill fitting clothing. Remove ties, watches, rings, other loose jewellery and contain long hair.
9
use mixer in an adequate working area for its function, keep area clean, tidy and free from unrelated materials and ensure adequate
lighting.
8
DO NOt
over-reach and ensure the floor is not slippery and wear non slip shoes. maintain correct balance and footing.
9
Always use both handle grips during use.
9
Keep children and unauthorised persons away from the working area.
9
Avoid unintentional starting of the mixer.
8
DO NOt
use the mixer for a task which it was not designed to perform.
8
DO NOt
operate mixer where there are flammable liquids or gasses.
8
DO NOt
get the mixer wet or use in damp or wet locations.
Pm120l110V | Issue 2 (3) 17/05/18
Original Language Version
© Jack Sealey limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves
Wear safety
footwear
Wear ear
protection
