A B
C
A : Strong feel
B : Normal feel
C : Light feel
Pull Cam
Key Bolt
Cam Wheel
Key Bolt
Drive
Connector
Key Bolt
Heel Plate
VariSet Footboard Angle Adjustment
The Footboard angle can be adjusted in two ways. By
loosening the Key Bolt on the Pull Cam, you can change the
Footboard angle infinitely (Fig.8). You can also change the
angle by loosening the Key Bolt on the Cam Wheel, and
sliding the Drive Connector to one of the three positions
(Fig.9). Make sure to tighten the Key Bolts after
adjustments.
PowerShifter Adjustment
The PowerShifter function allows the feel of the pedal to be
changed from Strong, Normal, and Light.
To change the feel, loosen the Key Bolt on the Heel Plate
and move the Footboard to the A, B, or C position. Tighten
the Key Bolt to secure the Footboard (Fig.10).
Spring Tension Adjustment
The spring tension can be adjusted
quickly and precisely by turning the
Spring Tension Dial. This innovative
system features extended tension
range and click-stops for slip-proof
performance under the most
demanding playing conditions
(Fig.11).
Hi-Hat Cup Tilt Adjustment
Turn the Knurled Knob to tilt the
bottom cymbal to help prevent "air
lock" between the cymbals (Fig.7).
Fig.7
Fig.9
Fig.10
Fig.11
Fig.8
Knurled Knob
Strong
Light
Fig.6-B
Fig.6-C
Fig.6-A
Top Hi-Hat
Cymbal
Bottom Nut
Rubber
Washers
Upper Tube
Upper Pull Rod
Stop Lock
Top Hi-Hat Cymbal
Lower Hi-Hat Cymbal
Hi-Hat Clutch
Die-Cast Joint
Wing Nut
Hi-Hat Cup
Bottom Nut
Connector
Upper
Pull Rod
Upper Section Assembly
Thread the Upper Pull Rod into the Connector inside the
Die Cast Joint as shown in (Fig.6-A) and tighten securely.
Insert the Upper Tube into the Die Cast Joint and set the
height to your preference then tighten the Wing Nut. Set the
Stop Lock by loosening the Key Bolt and sliding the Stop
Lock against the Die Cast Joint, then retighten the Key Bolt.
Thread the Lower Hi-Hat Cymbal through the Upper Pull
Rod and place it on the Hi-Hat Cup. Assemble the Top
Hi-Hat Cymbal and the Hi-Hat Clutch as shown in (Fig.6-B).
Tighten the Key Bolt on the Bottom Nut (Fig.6-C) to prevent
it from loosening during performance. Mount the Clutch
with the Top Hi-Hat Cymbal attached to the Upper Pull Rod.
Adjust the distance between the top and bottom cymbals to
your preference then secure the Clutch by tightening the
Wing Nut.
Tip
If the Footboard angle is set too high or too low, the action of the
Release Button (for the Interchangeable Cam system) can be
impaired. Should this happen, slightly readjust the angle of the Pull
Cam until the Release Button moves freely.
Wing Nut
