90°
2-B
2-C
2-A
CAUTION
Do not use the stand tilted. It would loose stability and would cause
the stand to fall over.
CAUTION
Depending on the position of the legs, the stand could become
unstable and fall over. Make sure that the stand itself is stable
before performance.
Fig.2-A, 2-B, 2-C
Strut End
Clamp
Key Bolt
Key Bolt
Base Assembly
Hold the Pedal Frame with one hand. Loosen the Key Bolt
on the Support Casting and disengage the Tab (Fig.1-A).
Remove the Pedal Frame from the Docking Station as
shown (Fig.1-B), and tighten the Key Bolt to prevent noise
while performance.
Loosen the Key Bolts on both sides of the bottom of the
Support Casting, and open up the Clamp (Fig.2-A). Insert
the Strut Ends at the end of the Pedal Frame into the
Clamps at the angle shown (Fig.2-B). Make sure that the
Strut Ends are inserted all way in, and then rotate the Pedal
Frame downward as shown (Fig.2-C).Tighten the Key Bolts
on the Clamps to secure the Strut Ends.
Set the Base Section vertically.
Heel of the Footboard
Fig. 3
Fig. 4
Stand the base up and
holding it with one hand,
loosen the Wing Bolt and
open the legs. Make
sure that the legs are
forming a stable tripod,
and tighten the Wing Bolt
to retain setting (Fig.3).
Make sure both the Support Casting and the Heel part of
the Footboard are touching the playing surface, and that
the stand is set vertically (Fig. 4).
Wing Bolt
Fig. 5
The legs can be swiveled to
fit your setting. Loosen the
Wing Bolt and the Key Bolt
as shown in (Fig.5). Swivel
the legs to the desired
position and tighten the
Wing Bolt and Key Bolt to
retain the setting.
Wing Bolt
Key Bolt
Fig.1-A, 1-B
Docking Station
Support Casting
Key Bolt
Tab
Pedal Frame
1-B
1-A
