ASSEMBLY INSTRUCTIONS
1.
Unpack the contents of the box and check to make sure that all items are accounted for and in good condition.
2.
Select a flat, level surface for the assembly and final location of your fountain.
3.
Place the pedestal on a flat, level surface, lead the power cord through the pipe in the middle of the fountain basin and through the hole of the
pedestal, make it go through the pedestal to the very bottom and pull it out through the power cord slot, align the arrow sign on both the fountain
basin and the pedestal, and then twist the basin to the pedestal clockwise until the parts are secured together. .And place the pump upright onto
the fountain basin. (Fig1)
4.
Insert the water supply tube from the underside of the middle basin into the pump outlet on top of the pump
，
align the middle base and basin and
twist it for lock ( Fig.2)
5.
Add clean water into the basin. (Fig 3)
6.
Connect the pump plug to a GFCI outlet and the product will begin to function as intended.
7.
If the pump runs with low or high water circulation Check and adjust the regulator dial or slide on the front of the pump. Adjust the dial/slide
towards (+) to increase water flow or towards (-) to decrease water flow. (Fig. 4)
8.
To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing after the initial setup of your fountain.
It is highly recommended that this fountain be placed in an area where it cannot be damaged that might cause damaged with the fountain .
9.
Do not leave your fountain running for extended periods of time when no one is present to observe the performance.
10. Check the area around your fountain on a regular basis to ensure that there is no leakage.
NOTE: The diagrams shown are for illustrative purposes only and are not to scale
4
