5. Operation
5.1. Setting the Output Voltage of CH1 and CH2
-
+
-
+
Connect to the circoit
1.
Connect the power supply to the power source.
2.
Press the
POWER SWITCH
[1] to turn on the power supply.
3.
Press
AUTO CURRENT CUT OFF PROTECTION KEY
[27] to activate output. The
OUTPUT
INDICATOR
[25] will light up.
4.
For setting CH1, use the
CH1 VOLTAGE TUNE KNOB
[7] to adjust CH1 voltage and get the
desired output voltage.
5.
Connect the circuit to the
TERMINALS
[24,26]
6.
When the
CH1 CV/CC INDICATOR
[6] is in red color, adjust the
CH1 CURRENT TUNE KNOB
[19] to give a suitable current.
7.
For setting CH2 voltage, repeat the above steps using
CH2 VOLTAGE TUNE KNOB
[10], short
MAIN TERMINAL
[18, 20] and look at the
CH2 CV/CC INDICATOR
[11] instead.
Remarks:
If CH2 cannot be adjusted, check the
TRACKING MODE SELECTION KEY
[19, 23] is not
pressed.
If you want to preset a desired current output before connecting to the circuit, read Section 5.2
first.
Caution:
Make sure the
INPUT VOLTAGE SELECTOR
[33] set to a correct position Otherwise; it will
damage the power supply.
Do not short the MAIN TERMINALS over 1 minute; it will damage the power supply.
-21-
