USB-Connector, User Manual
9
For the installation proceed as follows:
■
Close ETS.
■
Run the “PEAKnx USB Connector” application stored on the USB flash drive to start the
installation wizard.
■
Open the tab “Install”.
■
Click on “ETS Integration” > “Execute Now”.
This starts the automatic configuration.
After the completion, a summary of the configuration is shown.
5.3 Connecting and disconnecting the hardware
Connecting the hardware
■
Connect the D-Sub-9P connector* of the USB-Connector to the KNX bus using a suita-
ble adapt
er, see chapter 4 KNX bus connection.
■
Connect the USB port of the USB-Connector to a Windows device.
*More information on the Pin-assignment of the D-Sub connector is located in the appendix
under
.
Disconnecting the hardware
You can unplug the adapter from the computer's USB port without preparation.
