PCAN-ISA – User Manual
10
2.2
Installation into the Computer
Do the following to install the PCAN-ISA card into the computer:
1.
Make sure that the computer is turned off (power switch at
the computer's supply unit).
2.
Open the casing and plug the PCAN-ISA card into an empty
slot on the computer's motherboard. For details please refer
to the documentation of the computer.
3.
In the computer replace a slot bracket with the supplied slot
bracket containing the D-Sub connector(s) for the CAN bus,
if applicable.
4.
For each CAN channel connect the flat cable to the
corresponding connector on the PCAN-ISA card.
You can look up the pin assignment of the 10-pin CAN
connectors on the card in section 0 on page 11.
Figure 3: Connectors for the cable(s) to the slot bracket (here: PCAN-ISA Dual
Channel, the single-channel version only has the left connector Ch1)
5.
Close the computer's casing.
Note:
Before switching on the computer, please follow the
procedure for modifying the computer's BIOS settings
described in the following section.