PCAN-Dongle – User Manual
8
5.
Deselect the
CAN device drivers
and select
CAN device
drivers Non-Plug-and-Play
.
Node:
The
CAN device drivers Non-Plug-and-Play
is only
available under 32-bit Windows. PCAN-Dongle does not work
under 64-bit Windows.
6.
Follow the further instructions.
Do the following to install the adapter:
1.
Turn off the computer.
2.
Connect the PCAN-Dongle with the wider port (25 pins) to
the free parallel port at the computer.
3.
Pull the keyboard connector from the corresponding port at
the computer.
4.
Connect the T-piece at the cable of the PCAN-Dongle to the
keyboard port.
5.
Reconnect the keyboard to the free end of the T-piece.
A configuration of the hardware is not needed. However, you
should check the settings for the parallel interface in the computer's
BIOS setup
.
If the computer has a parallel interface with EPP as well as ECP
properties, the corresponding setting in the BIOS set-up should be
ECP
(not
EPP
and not
EPP+ECP
). Although the extended properties
of the PCAN-Dongle usually will work with the last-mentioned
setting, some systems may have problems with it. Therefore the
setting for the “pure” ECP mode should be preferred.
Further information about the different operating modes of the
PCAN-Dongle can be found in section 4.3.