2.2 Internal Termination
The termination can be activated by solder jumpers on the circuit board, to
terminate one end of the CAN bus.
Tipp:
We recommend to do termination at the CAN cabling, for example
with the terminating resistors PCAN-Term (IPEK-003002) or
PCAN-MiniTerm (IPEK-003002-Mini). Thus, CAN nodes can be flexibly
connected to the bus.
2.2.1 Activate Internal Termination
Risk of short circuit!
Soldering on the CAN interface may only be
performed by qualified electrical engineering personnel.
Attention!
Electrostatic discharge (ESD) can damage or destroy
components on the card. Take precautions to avoid ESD.
Set the solder bridges corresponding to the desired settings.
Following figure on the next page shows the positions of the solder fields of the quad
channel card. The solder fields for the single and double channel card are located in
the same positions and can therefore also be taken from the figure. The table below
contains the possible settings.
2 Settings
PCAN-PCI Express FD
User Manual 2.0.0
© 2022 PEAK-System Technik GmbH
9
