4.
As diagram above you can set parameter for the selected preset with step by step. If you don’t
want to transmit some MIDI message you can set to
“oF”
that’s meaning “OFF” and the next
setting step will be skip.
5.
You can save setting to a preset memory by press
P4
switch. The FCB4N will goes out from the
preset mode setting and return back to the operation mode with programming mode enabled.
6.
If you don’t want to save any changes please press
P3
switch. The FCB4N will exit without
saving any changes and return back to the operation mode with programming mode enabled.
Note:
You can press
P1
switch to see the current setting topic/menu.
Factory Restore
You can reset the FCB4N to factory default setting. The data that you set in the EEPROM memory will be
erase and return back the factory default setting. You can restore the factory default by step following:
1.
Unplug you power from the FCB4N unit
2.
Press and hold the
P4
switch.
3.
Plug the power into the FCB4N unit.
4.
The
BANK/PROGRAM
display will be flashing with a dot so, it is processing on restore.
5.
Once you see it is on processing then you can release the
P4
switch.
6.
Wait for a moment until restore process completed. The FCB4N will initialization with factory
default setting.
MIDI Cable Support
The FCB4N is a standard MIDI foot controller so you can connect the FCB4N to any MIDI devices you want
via a standard MIDI cable. If you need to phantom power into the FCB4N unit, it is available. The circuit has
reserved MIDI DIN pin 2 for ground and pin 3 for supply but you have to jump on a pcb to enable. We
disable the phantom power for protection any damage to your MIDI devices. Please read your MIDI device’s
instruction before enable the phantom power.