Peachtree GaN400, Manual

Page: 6 / 10

POWER
AC INPUT 100 240VAC 50/60Hz -
ON OFF
Serial Number
RoHS
BALANCED
UNBALANCED UNBALANCED
INPUT BALANCED INPUT
RIGHT
BALANCED INPUT
LEFT
OUTPUT
SPEAKER
LEFT
L
R
INPUT
INPUT
INPUT
12V TRIGGER
CAUTION
RISK OF ELECTRIC SHOCK
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE !
DO NOT OPEN
WARNING
(OUT)
(IN)
GaN400
Type: Power Amplifier
Model: GaN400
Maximum power consumption is 1000W
RIGHT
SPEAKER
OUTPUT
ASSEMBLED IN USA
1 2 3 4 5 6 7
BACK PANEL
B
Power ON OFF Switch
/ :
Connects and disconnects AC INPUT to the unit when
the power cord is connected between the AC INPUT and a 100 240VAC 50 60Hz
- /
AC outlet
.
C
AC INPUT Fuse Holder
& :
For connection to a 100 240VAC 50 60Hz AC outlet
- /
using the included power cord The fuse can be replaced after turning the
.
POWER switch OFF and removing the power cord from the AC INPUT See
.
the SPECIFICATIONS section for the the specifc fuse values required for each
GaN400 model Caution using an improper fuse value may cause damage to the
. :
unit Peachtree Audio accepts no responsibility for any damage caused by the use
.
of improper fuse values
.
D
RIGHT LEFT SPEAKER Outputs
& :
Speaker binding post outputs that accept
banana connectors insert into hole on back of the post spade connectors
( ),
( , , ), ( ,
loosen position spade around post tighten pin connectors loosen insert pin
through hole on post tighten or bare wire connections loosen loop around post
, ) ( ,
or insert through hole on the post tighten
, ).
E
RIGHT LEFT BALANCED INPUT
& :
XLR style input that accepts a balanced
( )
differential audio signal from a preamplifer equipped with a balanced audio
output
.
F
RIGHT LEFT UNBALANCED INPUT
& :
RCA style input that accepts a standard
audio signal from a preamplifer equipped with an unbalanced output
.
G
INPUT SELECTOR
:
Push in for UNBLANCED input and out for BALANCED input
.
Note Do not change the input selection while the unit is powered on
: .
H
12V TRIGGER INPUT
:
Enables power on off control from another product with a
/
12V trigger output Insert one 3 5mm cable into this input and connect the other
. .
end to a 12V trigger output of the controlling product Once connected both
. ,
products should power on and off when using the on standby button on the front
/
panel or remote control of the connected product
.