Document Number: PD196-244R8
PD295-002
Page 20 of 28
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
Programming the STB Signal Input Type
The Interface Module must be programmed so that it knows
which TV source input needs the keys to be mapped to the
STB. When any other signal source is selected, all keys will
operate normally.
1. Enter the Interface Module Setup Menu (see
“Understanding Interface Module Setup Menus”
earlier in this manual)
2. Select
menu “Interface Module SETUP 6/6”.
3.
Set “STB Signal Input” to match the connection to the
STB. This is usually Tuner,
but may be “HDMI” or
“Component” for high definition STB’s.
4.
If “STB Signal Input” is “Tuner” then set the “STB Channel” to match
the STB’s modulated RF output. The illustration depicts the channel as
number 3 in this example.
5. Exit setup. Verify the STB signal is now displayed on the television.
INTERFACE MODULE SETUP 6/6
STB Signal Input
Tuner
STB Channel
003
STB Model
DC50X
Restore Factory Defaults
>
Flash Power LED
Off
DIAGNOSTICS
Interface F / W Ver
V3.05
TV CCI Ver
V4.6
IR Cable
Connected
Exit: SETUP/OK Cancel: POWER
