Document Number: PD196-173R8
PD295-001
Page 17 of 19
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 937-743-6010 Fax 973-743-6554
Restoring Factory Default Settings
The Satellite Interface configuration can be reset to factory defaults. Resetting to defaults cannot be undone. If the
Interface is connected to a PDI-P19W the default configuration will be optimized for the P19W’s keypad. It will not match
the settings that came preloaded onto the Interface.
1. Enter the Satellite Interface Setup Menu (See STB Interface Setup Menus
earlier in this manual).
2. Select menu “INTERFACE MODULE SETUP 6/6”.
3. Highlight the “Restore Factory Defaults” item.
4. Press “VOL►” to restore factory defaults. The operation will happen
immediately and cannot be undone.
Operation
PDi Satellite Interface operation is straight forward once configured. Site installations that involve a secondary “Off Air”
signal require additional instruction to provide a worry-free patient viewing experience.
Satellite Operation
1. Turn the TV On. A satellite channel should be displayed.
2. Channel the TV Up or Down. The satellite channel should follow.
3. Press the designated Guide button or press “00”. A channel guide should appear.
4. Select a channel from the Guide. The viewed satellite channel should follow the selection.
Off-Air TV Operation (Optional)
1. a. If using the TV Tuner for satellite programming, press the control button designated for STB Power (see
section “Programming for Off-Air Non-Satellite Channels Using OFF-AIR RF Pass-Thru”).
b. If using an input other than RF Tuner for satellite programming, press the TV/AV key repeatedly until the TV
Tuner source is selected.
2. The STB signal should disappear.
3. Channel the TV Up or Down. The TV should now tune the Off-Air channels (non-STB channels).
4. a. If using the TV Tuner for satellite programming, press the control button designated for STB Power again.
b. If using an input other than RF Tuner for satellite programming, press the TV/AV key again until the satellite
source is selected.
5. The Off-Air channel should disappear and be replaced with a satellite channel.
6. Press the TV’s power button to turn off the TV at any time.
INTERFACE MODULE SETUP 6/6
STB Signal Input
Tuner
STB Channel
003
Restore Factory Defaults
>
Flash Intface Pwr LED
Off
Power Save
On
DIAGNOSTICS
DTV Interface F/W Ver
V3.12
TV CCI Ver
V5.3
DirecTV Command Ver
V1.4
DirecTV Status
Connected
DirecTV RID
0000 0000 0000
Exit:SETUP/OK
Cancel:POWER
