Better Solutions Are Within Reach
®
MODEL NUMBER:
PDI-MCP
Document Number:
PD196-397R2
medTV® Mobile Cart Assembly
Page 12 of 13
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
Note: It will make the task easier if all four screws are started into the threaded holes
and then tightening one of them until the Arm supports itself on the Column.
5.
Before fully tightening the M8x20 screws on the top of the column, re-install the
M6x10 screws (removed in Step #3) on the face of the column, using the 4mm hex
wrench.
6.
Connect the coax and ethernet cables from the TV to the Connector Plate on the front
of the Column and use the cable guides from the hardware bag to maintain the
cable(s), as shown in Figure 17.
Figure 17.
7.
Using the included 5mm Hex Wrench, adjust the piston resistance at the screw
located near the bottom pivot of the arm. This will ensure that the Arm and TV
maintain their desired elevation. See Figure 18.