Better Solutions Are Within Reach
®
MODEL NUMBER:
PDI-AA1013 Series Arm
Document Number:
PD196-330R1
Installation Instruction for 1013 Series Arm
Page 8 of 10
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
1) Attach arm to wall bracket and mount TV to arm before beginning cover installation.
2) Arm Safety Brake Pin must be removed from arm nose to install the new Nose Arm Cover.
3)
DO NOT DISCARD SAFETY BRAKE PIN. Store the safety pin under one of the extra clamps in the nose of the arm, for future
service of the arm and/or TV.
Step 7.
Snap the (3) PD216-001 End Caps into the ends of the arm sections as pictured. There should be two in the front section and one in
the back section.
Step 8.
Attach the Base Cover halves PD216-002 using (2) PD209-004 screws each.
Step 9.
Securely snap the Elbow Covers PD216-003 around the elbow joint. Hook over the top edges of the elbow plates then snap the lower
hooks along the bottom edges.
When the halves are properly installed there should only be a thin seam visible where the halves meet.
Step 10.
Attach the left and right Nose covers PD216-009L, PD216-009R to the nose using (4) PD209-004 screws as pictured.
When the halves are properly installed there should only be a thin seam visible where the halves meet.
Step 11.
Rotate the TV and move the arm thru its range of travel to check for any inference issues.
PARTS LIST for KIT:
1. (3) PD216-001 End Caps
2. (2) PD216-002 Base Covers
3. (2) PD216-003 Elbow Covers
4. (1) PD216-009L Left Nose Cover
5. (1) PD216-009R Right Nose Cover
6. (8) PD209-004 Painted Cover Screws
TV is not shown for installation clarity.
