Page
Fuze Part # 4532 - Patent Pending
May 2007
May 2007
Fuze Part # 4532 - Patent Pending
Page
Page
Fuze Part # 4532 - Patent Pending
May 2007
May 2007
Fuze Part # 4532 - Patent Pending
Page
B. Locking Flip-up Arms
1) Use
a. Pull actuator D shown in
Figure 1 towards the front of the
wheelchair.
b. While holding the actuator of the
locking mechanism, lift up on the
cantilever arm.
127(,IQHFHVVDU\WKHORFNLQJ
mechanism in the cantilever arm
can be repositioned so the cantilever
arm will open down instead of up.
For this adjustment, contact a
TXDOL¿HGWHFKQLFLDQ
c. To lock the cantilever arm in the down position, push down until there is
an audible click.
d. Pull up on the cantilever arm to make sure it is locked in place.
2) Installation
127(:KHQUHPRYLQJWKHORFNQXWVDQGZDVKHUVIURPWKHFDQWLOHYHU
arm assembly, leave the top hex bolt, coved washers and spacer (between
adjustment plate and cantilever arm) in place.
a. Place the partially assembled cantilever arm assembly with mounting
hardware against the back cane at the desired height. Make sure the
adjustment plate is on the outside of the wheelchair.
b. Insert the bottom bolt (with coved washer) through the adjustment plate
and back cane.
c. Securely tighten the cantilever arm to the wheelchair with two locknuts
DQGZDVKHUV%LQ¿JXUH
d. Adjust the angle of the cantilever arm, if necessary. Refer to Step 3
below in this section of the manual.
3) Adjustment
e. Arm Angle Adjustment
127(7KLVDGMXVWPHQWLVUHFRPPHQGHGLIWKHEDFNDQJOHKDVEHHQ
changed.
i. Flip the cantilever arm up and out of the way.
ii. Remove the locknut that secures the locking pin to the arm adjust-
PHQWSODWH&LQ¿JXUH
Figure 1
19
