PAGE 26
Class 1 Medical
Rev. 2
Figure 14.18:
Easy-Out Angle
Adjustable Front Rigging
14.6.2
Easy-OutTM Front Rigging Footrest Assembly – Plug-in 70°, Adjustable Knee
Angle Front Rigging.
Plug-in 70° Front Rigging Footrest Assembly
Installation and Removal:
a.
To mount the easy out plug-in front rigging,
depress the lever located under the plug-in
and slide the front rigging into the open
square tube receiver (upper frame seat
rail). The fronting rigging will lock into
position when the lever snaps through the
hole located on the bottom of the square
receiver tube.
b.
To release the front rigging, similarly
activate the trigger to disengage the lever
from the hold and slide the front rigging
forward and out of the upper frame.
Plug-In Adjustable Knee Angle Front Rigging (Optional)
Installation and Removal of this option is the
same as the Easy-out Plug-in 70 Front Rigging.
To adjust the Knee Angle Front Rigging:
a.
Remove the plastic cover on the side by prying it
off by hand.
b.
Unlock the knee angle joint by loosening the
socket head fastener ½ a turn.
c.
Adjust the angle of the front rigging to the desired
location.
d.
Once set to the desired location, re-tighten the
socket head fastener and re-install the plastic
cover.
Footrest Height adjustment:
a.
Release the footrest extension adjustment lever.
This is shown in figure 14.18.
b.
Adjust the footrest extension to the desired
height.
c.
Fully depress the lever to lock the footrest
extension height.
Note: Height adjustment can be performed with the individual sitting in the
wheelchair with their feet on the foot plates. The lowest point of the foot
plates should be no less than 2” from the ground or floor.
Figure 14.17:
Easy-Out Plug-In
70° Front Rigging
Summary of Contents for BENTLEY
Page 43: ...PAGE 43 Class 1 Medical Rev 2...
