- 4 -
Use a Y-connector to attach the two servo wires together. This connection will be plugged into the receiver aileron
channel when you are ready for final assembly.
Fuselage:
Carefuly cut the canopy from the furnished material to fit the canopy frame. Glue the canopy to the frame using CA or
any other type of glue compatible with these materials.
The canopy frame is attached to the fuselage by fitting a small piece of dowel to the front portion of the frame to fit
into the front part of the fuselage. An included latch is used to hold the rear of the canopy in place. It is important to fit the
canopy carefully, because this will be your acces hatch for the receiver, the servos, and the wing attachement.
Make a 1/8th inch (3mm) plywood platform for mounting servos as per the dimensions in the diagram (in milimeters).
If the retract gear is not installed, make the platform only 80 mm long (you will not need cut-out for third servo).
Glue the servo holder to the fuselage and mount servos.