PCS DTC6 Installation And Operating Instructions Manual Download Page 3

About Your WMC6 Wall-Mount 6-Button Controller 

Congratulations on your purchase of a WMC6 Wall-Mount 6-Button Controller.  We feel that the 
6-Button Controller is the perfect choice for controlling your UPB

TM

 Lighting System devices 

(e.g. Wall Switch Dimmers, etc.) to create a dramatic home lighting system.  After installing and 
configuring your WMC6 you’ll be able to transmit standard UPB™ commands over the existing 
powerline to remotely control your UPB

TM

 Lighting System devices and be able to see its 

pushbuttons light-up for feedback.   
 
The WMC6 (see Figure 1) has six pushbuttons normally labeled 

ON

A

B

C

D

, and 

OFF

 (see 

NOTE below) with LED backlighting and two buttons (

UP

 and 

DOWN

) without backlighting.  All 

of the components of the WMC6 are highly configurable so that you can customize them to 
operate your UPB

TM 

Lighting System the exact way you desire.    

 

 

Figure 1: The WMC6 Wall-Mount 6-Button Controller 

 

About Your DTC6 Desk-Top 6-Button Controller 

The DTC6 Desk-Top 6-Button Controller is basically the same as the WMC6 described above 
except it is packaged in a plastic case with a line cord to plug directly into a wall outlet.  The 
DTC6 requires no installation instructions.  Simply plug it in and begin controlling your UPB 
Lighting System devices. 
 

ON Button 

B Button 

C Button 

D Button 

OFF Button 

A Button 

UP/DOWN 

Button 

IR Receiver 

(Future) 

NOTE: Custom engraving of the keypad pushbuttons can be ordered on the PCS web site 
for a nominal charge.  Custom engraving allows the user to identify each button for ease 
of use and to add beauty and functionality to any room. 

Page 2 of 8 

Summary of Contents for DTC6










Reviews: