www.modellmarkt24.ch
FW6.2 Building Instruction October 2015
www.pcm.at
7
Then set the servo to the
zero position and mark,
where the
steel must be
bent at the aileron side
.
In order to be able to bend
the steel,
push
the steel
as much as possible
to the
rear
and
fix it with a tape
to make sure that the steel
won’t move while bending
.
First, bend the steel
90°
in
direction of the lever.
Then, bend it a
little bit
upward
s.
Open the hole of the
lever
to have a
good
fitting
without much
friction and without getting
too much clearance.
Then put the lever into the
aileron for a test.
Grind on
the necessary areas
to
get a free movement.
Check, if the
recommended
deflections
are possible
.
Solder the servo cable
to the contact before you glue the servo
into the box.
Before you start gluing grind all gluing spots well.
First,
glue the lever
into the aileron.
Then set the servo to zero and also the aileron (fix the aileron
with a tape) and
glue the servo
into the box.
www.modellmarkt24.ch
