www.modellmarkt24.ch
FW6.2 Building Instruction October 2015
www.pcm.at
3
DATA
1. Kit
–
contents
Fu canopy
Wing
Rudder and elevator CFR
Radio board
CFR ballast tube
Lever for controlling rudder, 1 pc.
Lever for controlling elevator, 1 pc.
Kevlar wire for controlling rudder and elevator
Steel wire for torsion springs, 2 pc.
Lever for controlling ailerons, 2 pc.
1,5mm steel wire for controlling ailerons, 4 pc.
Screws for fixing wing, 2 pc.
Nylon screws for fixing elevator, 2 pc.
Throwing blade, 1 Stk.
Lead balls for ballast
1,5mm normal steel wire for ballast
Spring-loaded contacts
Building instruction (for download from our website)
2. What else do you need:
Epoxy-glue (for example UHU 300 endfest or Pattex Stabilit)
Super glue, both runny and thick
Carbon rovings
Electrical equipment (On/Off-switch, cables, plug...)
Electronic equipment
Shrinking tube...
3. Electronic equipment
Servo aileron:
- KST X08
Servo rudder and elevator:
- Dymond D-47 (cuttings on radio board are prepared for this servo)
Same style:
- Futaba FS31
- Modell Expert X31
Accumulators:
- GP NiMH Accu 35AAAH, Weight/cell 6g
(1,2 Volt 0,35 Ah 1/2AAA)
Receiver:
- 2,4GHz possible due to kevlar fuse cone
- Futaba R6106HFC FASST
- Multiplex RX-5 light M-link
- Mulitplex RX-6 light M-link
- Spektrum AR6115e
- Orange RX DSM2
Apart from RX-6 all receivers must be removed from their casings and
covered with heat shrink tube. See Chapter receiver installation.
www.modellmarkt24.ch
