Screws
Blade Bracket
Blade Bracket
Screw
Paper Washer
Blade
Washers
!
!
WARNING
!
!
WARNING
MOTOR IS SHIPPED WITH RUBBER MOTOR
BLOCKS TO PREVENT MOVEMENT DURING
TRANSPORTATION. REMOVE MOTOR BLOCKS
PRIOR TO ATTACHING BLADE BRACKETS.
LOCKING SLOTS OF CEILING CANOPY ARE
AN AID TO MOUNTING, DO NOT LEAVE FAN
ASSEMBLY UNATTENDED UNTIL ALL FOUR
CANOPY SCREWS ARE ENGAGED AND FIRMLY
TIGHTENED.
8
Finishing The Fan Installation
Figure 16
Figure 17
Attaching the Fan Blades
2. Tighten each screw securely.
3. Fasten the blade assembly to the motor by
inserting the alignment post into the slot on
the bottom of the motor and tightening the
motor screws. Please note that the motor
screws may be pre-attached into the blade
brackets (Figure 17).
4. Repeat steps 1-3 for the remaining blades.
1. Attach blade to blade bracket using the screws
provided (Figure 16). Insert a screw into the
bracket. Repeat for the two remaining screws.
1. Align the locking slots of the ceiling canopy with
the two screws in the mounting plate. Push up
to engage the slots and turn clockwise to lock
in place. Immediately tighten the two mounting
screws firmly.
2. Install the remaining two mounting screws into
the holes in the canopy and tighten firmly.
3. You may now proceed to attaching the fan
blades.
1. Carefully unhook the fan from the mounting
plate and align the locking slots of the canopy
with the two screws in the mounting plate.
Push up to engage slots and turn clockwise
to lock in place. Immediately tighten the two
mounting screws firmly.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten firmly.
3. You may now proceed to attaching the fan
blades.
Close-to-Ceiling Mounting
Standard Ceiling Mounting
8002 ∙ 06/23/11 ∙ PCI
