Manual
10
5.3 To replace the battery
To replace the battery, make sure that the device is turned off. Now move the cover of the battery
compartment downwards, while you push the mark on the cover. After that, you can carefully remove the
cover and remove the battery by releasing it carefully from the plug-in connectors. Next, insert a new
battery and slide the cover of the battery compartment upwards to close it.
6 Setup
To access the setup menu, press and hold
for 3 seconds. Now the “SETUP” indication appears.
To exit the setup menu, press and hold
again for 3 seconds.
In the setup menu you have the following options:
“UNIT” – Here you can choose the unit of the cross-sectional area. You can switch between in²,
m² and ft².
“AREA” – Here you can adjust the cross-sectional area.
“SLP” – Here you can activate / deactivate the Auto Power Off function.
To navigate through the menu, use
and
until you see the desired option on the display. Then,
press
to confirm.
6.1 Set the unit of the cross-sectional area (UNIT)
To access the unit selection screen for the cross-sectional area, use
or
until the display
s
hows “UNIT” (Fig. 1). Now press
to confirm. An “AREA” indication should appear on the display.
This means that you can now select the unit of the cross-sectional area by using
and
. The
se
lected unit is shown next to the “AREA” indication. To confirm your selection, press
. To exit the
setup menu, hold
for 3 seconds.
Summary of Contents for PCE-423
Page 8: ...Manual 8 Flow rate sensor flow direction...
Page 11: ...Manual 11...
