Manual
28
7.2
Vertical machine alignment
Mount the measurement sensor, marked as
S
, to the shaft of the stationary machine and the
measurement sensor marked as
M
to the moveable machine.
Note:
Mark the 3, 6, 9 and 12
o’clock position on the machine housing.
Connect the cable as described in chapter 5.3
“Connection of the measurement sensors”
or configure
the Bluetooth-interface (only with optional Bluetooth adaptor).
What should be noticed in this window
Shortcuts in this window
Check the result after the alignment,
by measurement again
Determine new data
Functions in this window
Continue alignment process
-
Determine new data and start the
alignment
-
Continue the alignment
-
Change parameters
-
Change dimensions and distances
-
View/change
Change the machine dimensions and distances
Add/change parameters
Thickness of the front
machine base
Thickness of the rear
machine base
Remaining misalignment
Measurement
unit
