Remark :
How to set the sampling time, refer to Chapter 7-2, page 18.
In Dose mode please start datalogger , then run Dose Function.
b. Pause the datalogger
During execute the Datalogger function , if press the
" ENTER Button " ( 3-7, Fig. 1 ) once will pause the
Datalogger function ( stop to save the measuring data
into the memory circuit temporality ). In the same time
the text of " LOGGER " will stop flashing.
Remark :
If press the " ENTER Button " ( 3-7, Fig. 1 ) once again
will execute the Datalogger again, the text of " LOGGER " will
flashing .
c. Finish the Datalogger
Press the " ENTER Button "( 3-7, Fig. 1) continuously at
least two seconds, the " LOGGER " indicator will be
disappeared and finish the Datalogger.
Remark :
When the battery is under the low battery condition
( show the low battery indicator ), the Datalogger
function is maybe disable.
d. EEPROM Datalogger data send to SD card or RS232.
a. Insert the SD card
Prepare a " SD memory card " ( 1 GB to 16 GB, optional ),
insert the SD card into the " SD card socket " ( 3-15, Fig. 1).
The front panel of the SD card should face against the
down case.
*
It recommend use memory card
≦
4 GB.
b. SD card Format
If SD card just the first time use into the meter, it
recommend to make the " SD card Format " at first. ,
