19
Chapter 3: BIOS Setup Utility
DRAM CAS# Latency
This item determines the operation of DRAM memory CAS (column address
strobe). It is recommended that you leave this item at the default value. The 2T
setting requires faster memory that specifically supports this mode.
Auto detect DIMM/PCI Clock
When this item is enabled, BIOS will disable the clock signal of free DIMM/PCI
slots.
Spread Spectrum
If you enable spread spertrum, it can significantly reduce the EMI (Electro-
Magnetic interface) generated by the system.
CMOS SETUP UTILITY – Copyright (C) 1985-2003, American Megatrends, Inc.
Features Setup
Help Item
Allows BIOS to Enable or
Disable Floppy Controller.
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Optimized Defaults
Enabled
3F8/IRQ4
Disabled
378
ECP
DMA3
IRQ7
Both
Enabled
Auto
Enabled
Enabled
Disabled
OnBoard Floppy Controller
Serial Port1 Address
OnBoard IR Port
Parallel Port Address
Parrllel Port Mode
ECP Mode DMA Chnnel
Parallel Port IRQ
OnBoard PCI IDE Controller
Audio Device
Modem Device
Ethernet Device
OnBoard USB Function
USB Function For DOS
Features Setup Page
This page sets up some parameters for peripheral devices connected to the
system.
OnBoard Floppy Controller
Use this item to enable or disable the onboard floppy disk drive interface.
Serial Port1 Address
Use this item to enable or disable the onboard COM1/2 serial port, and to assign
a port address.
OnBoard IR Port
Use this item to enable or disable the onboard infrared port, and to assign a port
address.
Parallel Port Address
Use this item to enable or disable the onboard Parallel port, and to assign a port
address.
