3: BIOS Setup Utility
Quick Boot
If you enable this item, the system starts up more
quickly be elimination some of the power on test
routines.
1
st
Boot Device
2
nd
Boot Device
3
rd
Boot Device
Use these items to determine the device order the
computer uses to look for an operating system to
load at start-up time.
Try Other Boot
Device
If you enable this item, the system will also search
for other boot devices if it fails to find an operating
system from the first two locations.
S.M.A.R.T. for
Hard Disks
Enable this item if any IDE hard disks support the
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting
Technology) feature.
BootUp Num-
Lock
This items determines if the Num Lock key is active
or inactive at system start-up time.
Floppy Drive
Swap
If you have two diskette drives installed and you
enable this item, drive A becomes drive B and drive
B becomes drive A.
Floppy Drive
Seek
If you enable this item, your system will check all
floppy disk drives at start up. Disable this item
unless you are using an old 360KB drive.
Password Check
If you have entered a password for the system, use
this item to determine if the password is required to
enter the Setup Utility (
Setup
) or required both at
start-up and to enter the Setup Utility (
Always
).
Boot to OS/2 >
64MB
Enable this item if you are booting the OS/2
operating system and you have more than 64MB of
system memory installed.
L1/L2 Cache
Leave these items enabled since all the processors
that can be installed on this board have internal
cache memory.
System BIOS
Cacheable
If you enable this item, a segment of the system
BIOS will be cached to main memory for faster
execution.
Timing Setting
Mode
Use this item to determine the timing setting mode
of the memory. We recommend that you leave this
item at the default value.
SDR/DDR CAS
Latency
This item determines the operation of the
SDRAM /DDR memory CAS (column address
strobe). We recommend that you leave this item at
the default value. The 2T setting requires faster
memory that specifically supports this mode.
Auto Detect
DIMM/PCI Clk
Use this item to enable the DIMMs or PCI slots to
detect automatically device then generating clock.
23
Summary of Contents for M830LU
Page 4: ...Mainboard User s Manual IV ...
Page 22: ...Mainboard User s Manual 18 ...
Page 37: ...3 BIOS Setup Utility 33 ...
