MODELS 483C30, 483C50, 482M179 AND 483M217 GENERAL OPERATION MANUAL
12
Following this screen the right panel will appear as shown below. Click on the ‘Connection’ item and check to see that
the parameters are shown as below and pay particular attention to the ‘Active Connection’ and ‘Endpoint’ Port items.
They should be set as shown below.
Next, check the Serial Settings. They should be 19200 baud, 8 data bits, no parity, 1 stop bit. And no flow control.
If any setting is changed click ‘Ok’ on the page and then activate the ‘Apply Settings’ item on the left side of the right
panel.