PB Heat Peerless Partner PV-120, Operation And Installation Manual

Page: 10 / 31

9
INSTALLATION CHECKLIST
A. INSPECTING AND PREPARING THE HEATER
 Remove the cardboard box, which comes packaged with the
heater. It should contain the following: Thermostat, T&P
valve,
brass “T”, insulation, lid and screws.

Do not cover T&P relief valve opening.
B. LOCATION
 Solid foundation and dry location.
 Protect heater water lines from freezing.

Area free of flammable vapors.

Sufficient room to service heater.

Not in close proximity to wood burning stove.
 Where leak will not damage property.
C. PROTECTION FROM WATER DAMAGE
 Be sure to make provisions to protect area from water
damage if a leak should occur in the tank or connected
fittings.
D. TEMPERATURE AND PRESSURE RELIEF VALVE
 Warning: Improper installation will present potential
hazard to life and property.

A T&P Relief Valve with an 8-inch stem should be used.
 Check to be sure that proper relief valve requirements are
met.
 T&P installed as shown in FIGURE 1 and FIGURE 2.

3/4" discharge pipe
– properly protected from freezing and
restrictions.

No valve between tank and relief valve or in drain line.
 Provision for hot water discharge from relief valve.
E. BOILER SUPPLY CONNECTIONS

R
eturn line (back to the boiler) connected to the “Hx Out”
fitting.

Supply line (from the
boiler) connected to the “Hx In” fitting.
F. WATER SUPPLY CONNECTIONS (See FIGURE 1 and
FIGURE 2.

Do not over tighten brass threads.

Mark the water shutoff for future reference.
 Do not apply heat to cold inlet.