ATTENTION!
The thermodisc is set to turn on at approximately 120° F and
will shut off at approximately 90° F.
NOTE:
Blower
will not start
until thermodisc is heated to approximately 120° F.
The thermodisc has been factory tested.
PayandPack.com
2. Installation Solution 2 for select model fireplacs.
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
BlotsdV automatIc thermostat Blower
Before installing the blower, wire the receptacle into an
electrical circuit. This should be done before framing the
fireplace. Wire with minimum 60° C wire in accordance
with prevailing codes.
Page 3
