BLOTBLDV / BLOTSDV Fan Kit
Intended to be installed by a qualified technician.
The Fan Kit has been designed to circulate room air through the appliance to
enhance heat output.
factory installed junction box. Plug corset into outlet marked “auxiliary”. The junction box is located in
the controls compartment of the appliance.
Because the blower is thermally activated, when turned on, it will automatically start approximately 10
minutes after lighting the fireplace and will run for approximately 30-45 minutes after the fireplace has
been turned off. Use of the fan increases the output of heat.
CAUTION:
Drywall dust will
penetrate into the blower bearings, causing irreparable damage. Care must be taken to
prevent drywall dust from coming into contact with the blower or its compartment. Any
damage resulting from this condition is not covered by the warranty policy.
Installation Precautions
The is tested and safe when instal led in accordance with this installation manual.
It is your responsibility to read all instructions before starting installation and to follow these instructions
carefully during installation to ensure maximum benefit from, and safe operation of the fan.
WARNING
Shock Risk / Explosion Risk
- DO NOT wire 110-120 VAC to gas control valve
- DO NOT wire 110-120 VAC to wall switch
•
Incorrect wiring will damage millivolt values
•
Incorrect wiring will override IPI safety lockout and
may cause explosion
NOTE:
This appliance must be electronically wired and
grounded in accordance with local codes, or in the absence of
local codes, with
National Electric Code ANSI/NFPA 70-
latest edition
or the
Canadian Electric Code CSA C22.1
CAUTION
Sharp Edges
•
Wear protective gloves and safety glasses during
installation
BLOTBLDV & BLOTSDV
This is available through a receptacle in the
The fan kit operates on 120 VAC, 60 Hz power.
BLOTBLD/BLOTSDV
This is a factory replacement kit. The blowers are aftermarket
models with LIMITED INSTRUCTIONS!
NOT original parts.
INSTALLATION INSTRUCTIONS
PayandPack.com
Page 1
