PAXXO Pactosafe 4.0 540WM, Original Instructions Manual

Page: 16 / 41

Paxxo AB / Bjurögatan 35, SE-211 24 Malmö, Sweden / Tel: +4640186025/ Fax: +4640183736 / www.paxxo.com
16
12. Troubleshooting
Fault Possible cause Action
Nothing happens when
pressing the foot pedal.
The Pactosafe is not connected to a
mains socket Connect the Pactosafe to a mains
socket.
Switch not on. Turn on the switch.
No signal from foot pedal.
Check its connection and whether it is
damaged. Shorten or replace if
necessary.
The Pactosafe is starting up.
The system takes 5 seconds to
become operational.
Battery discharged Charge battery
The feeding of the foil
works but not the
welding.
Something is jamming the cog wheels
and is blocking the welding bars. Remove the item causing the
blockage.
The welding bars are damaged. Contact the distributor/manufacturer.
Something is wrong inside the unit. Contact the distributor/ manufacturer.
Incomplete welding of
the foil. See picture in
Section 10.
The welding bars are damaged. Contact the distributor/ manufacturer.
Something is wrong inside the unit. Contact the distributor/ manufacturer.
The welding of the foil
is too powerful. See
picture in Section 10.
Something is wrong inside the unit. Contact the distributor/ manufacturer.
The foil is adhering to
the welding bars.
The welding bars are damaged. Contact the distributor/ manufacturer.
Waste is stuck
between the welding
bars. Switch the unit OFF and then ON
again. The Pactosafe will then return
to its start mode.
If the error remains, contact the distributor/manufacturer. The plug-in units are repaired and delivered
in tailor-made boxes. When ordering, a newly repaired plug-in unit is sent with replacement
instructions, and the defective plug-in unit should be returned in the same box.
5410
Funnel Wide
5424 Power adaptor
5617 Power cable
5426 Battery charger
5428 Battery pack
543WS Plug-in unit
543WM Plug-in unit with battery
5524 Knobs
5602 Foot pedal
Wing nuts for legs
ON / OFF Switch
Connection to foot pedal