1
10
1
100
2.405 GHz
30 m
100V AC
240V AC
10V DC
14V DC
150 mA
0.4 W
3.8 W
-20 °C
55 °C
70 mm
195 mm
100 mm
Specifications
Carrier frequency
Environment
Dimensions
Min
Max
Width
Height
Length
System Specification
DC supply voltage
Electrical
DC supply current
Waterproof
Min
Max
Min
Max
ACU's per Net2Air bridge - Recommended
No
Net2Air USB bridge per system
Operating temperature
Net2Air wireless range
Net2Air Ethernet bridge per system
Power over Ethernet (PoE) power rating
Mains supply voltage
IEEE 802.3 af
The declaration of conformity is available on request. Contact details are provided at:
http://paxton.info/596
This product is not suitable for retail sale. All warranties are invalid if this product is not installed by a competent person.
Data Reset
To clear all settings back to their factory default, including clearing the current IP address and setting the bridge
to acquire new addresses using DHCP, power on the unit with the reset button held down for 3 seconds. This is
located at the rear of the unit through a small hole beneath the power connection.
The unit will beep to acknowledge once the reset is complete.
Sounder
The device will 'beep' when detected by the Net2 Server Configuration Utility or when new IP settings are applied.
The sounder will also respond to a direct 'Ping' over the network. This is a feature to assist with finding devices
hidden from view.
Page 3
Net2Air Site Surveyor (690-200).
This access control unit uses wireless communication. It is recommended that a Net2Air site surveyor is used to
determine the best position for the bridge and control units.
