5 Assembly and installation [specialist]
20
9945x1051x-mub-en – V03
2018/11
6.
If you do not mount the communication
set, continue at point 10.
7.
If you additionally mount the optional
communication set, run the bus line
of the communication set to the first
(left) controller. For this purpose,
disconnect the plug of the bus
line from the mini PC of the
communication set.
8.
Make sure that the plug does not
get wet.
9.
Mount the optional communication
set now. Please observe the
separate instructions of the
communication set!
10.
Carry out the electrical
commissioning of the controllers
(see controller instructions).
11.
Carry out the electrical commissioning
of the communication set (see
instructions of communication set).
12.
Mount the insulating front shell of
the controller.
13.
Screw the screws in the controller
insulation.
14.
Mount the insulating front and back
shells of the HeatBloC.
15.
Mount the handles and insert the
thermometers.
16.
Mount the insulating front and back
shell of the distribution manifold.