1 General Information
2014/11
99640766x-mub-en – V03
5
1.2
About this product
The domestic hot water module is a premounted fitting group checked for leakage and used
to transfer the heat between the buffer tank and the domestic hot water circuit.
It contains a preset controller and important fittings for the operation of the system:
•
Ball valves in the primary circuit
•
Piston valves in the secondary circuit
•
Pressure relief valve in the secondary circuit
•
Premounted controller
•
Temperature sensor on the cold water inlet
•
Temperature sensors on the heating flow
•
Temperature sensor on the domestic hot water outlet
•
Flow meter on the domestic hot water outlet
•
Fill and drain valve for draining the heat exchangers in the primary and secondary circuit
•
Vent valve, primary and secondary, for venting the heat exchangers
1.3
Designated use
The domestic hot water module must only be mounted in heating installations between
the buffer tank and the domestic hot water circuit.
Due to its design, the station must be mounted and operated in a vertical position!
The technical data specified in these instructions must be observed.
Only use PAW accessories with the domestic hot water module.
Improper usage excludes any liability claims.
The wrapping materials are made of recyclable materials and can be disposed of
with recyclable materials.
