Page 30
In-oUt
SET
FUN
SEr1aL
SET
FUN
AnaLoG
baUd r
prot-1
prot-2
AddrEs
dELay
rEN-Co
data F
0
0
0
0
0
0
0
PRG
SET
FUN
SET
FUN
SET
FUN
SET
FUN
SET
FUN
SET
FUN
SET
FUN
PRG
Select Value
PRG
PRG
Select Value
PRG
PRG
Select Value
PRG
PRG
Enter Value
PRG
PRG
PRG
Remote
connection
PRG
Select Value
PRG
PRG
Pr-Add
0
SET
FUN
PRG
Enter Value
PRG
Enter Value
PRG
SERIAL OUTPUT PARAMETERS
This menu allows you to set the serial ports COM1 and COM2 and the communication parameters.
The instrument has two independent serial ports connected to a single connector:
COM1 with RS232 or RS422 / RS485 interface
COM2 with PROFINET interface.
baUd r
BAUd RATE COM1
It defines the baudrate of the serial port RS232.
The value must be set to the same value of the PC / PLC or remote
display.
Value to be selected:
2400
9600
19200
38400
115200
Default: 9600
Prot-1
COM1 PROTOCOL
It defines how to use the serial port RS232
None:
Serial communication OFF
Contin:
Continuous transmission of the weight string. It can be used,
for example, to drive a weight repeater. See details in the relevant
paragraph.
deman:
When the Operator presses the front button or through Input
2, a string of weight is transmitted. The command is accepted if the
weight is stable. Between two consecutive transmissions the weight
must have a variation of at least the parameter “Weight delta”.
Auto:
It’s automatically transferred to a string of weight when the
weight stabilizes at a value higher than the minimum weight (20
divisions). Between two consecutive transmissions, the weight must
have a variation of at least the parameter “Weight delta”.
Slav:
ASCII protocol. See details in the relevant paragraph.
Mdbs:
MODBUS RTU (slave) protocol. used only if PROT-2 is confi-
gured equal NONE. Selectable communication patrameters:
n-8-1
n-8-2
E-8-1
o-8-1
Default: n-8-1
