7
Tip#2 Set aside your two tiller springs, we will install those later after the rudder is mounted.
With the aircraft resting on the landing gear, we are going to need to set the right angle for the wheel
pants. We used wood scraps to position the wheel pants properly. Mark the drilling location for the 4/40
bolts.
Drill the holes for the 4/40 bolts in the wheel pants at the locations you’ve marked.
Apply some white wood or epoxy glue to the inner side of the four 4/40 blind nuts and install the blind
nuts to the inside of the wheel pants.
Now you can install the wheel pants with the 4/40 bolts and washers. Don’t forget to use loc-tite here
again. Wheel pants tend to take the most vibration.
