39
Installing the nodes using the Datamars Livestock app and mounting them on the fence
After all of the nodes have been paired, they can be installed on the fence. Before you begin
the installation process, make sure that you have paired all the nodes in your system. The
installation process requires each of the nodes to be installed using the Datamars Livestock app,
then physically mounted on the fence. Nodes can be mounted on a wood or steel fence post.
To install the nodes, you will need:
• All of the paired fence nodes you‘ll be using in your system.
• A mag key to activate the nodes (supplied).
• A mobile phone with the Datamars Livestock app installed.
• A compass or a compass app on your mobile phone.
• A pair of binoculars so that you can establish a clear line-of-sight between the center/
gateway and the nearest node and between each of the nodes.
• An impact driver and pozi drive screw bit, 8 mm and 10 mm hex sockets
• Wire cutters/strippers
• 10 mm spanner
• Node mounting kits (1 per node, supplied).
• Insulated underground fence cable for a lead-out cable and an earth cable (2- 3 m per
node). Not supplied.
• Joint clamps (2 for each node - one for the earth connection and one for the fence
connection). Not supplied.
• 20 - 30 cm earth stakes e.g. a 3 mm thick tent peg (1 for each node). Not supplied.
• Alternative: Mobile fence connection set
• Cable ties. Not supplied.
The installation process needs to be done on the farm, not near the center/gateway.
1. Launch the Datamars Livestock app.
2. If the nodes have been paired but not installed, a message will appear inviting you to
„Install nodes“. Tap to begin.
3. Drive to the location where the first node will be mounted. It must be within 500 m of the
center/gateway. Note that this is a line-of-sight measurement and the distance will be
reduced if there are any objects in the way, e.g. trees, hills or structures. Use a pair of
binoculars to assist you.
4. Follow the steps to set up the node. When prompted, reset the node using the mag key;
physically mount the node on the fence using the following instructions; scan the QR code;
assign a unique name (e.g. „back paddock“, „letterbox“, „hay shed“) and set a
geo-location.
Turn OFF the electric fence before you install the nodes.
