Installing the Patton SmartNode ESBR
26
SmartNode 5570 User Manual
3
• SmartNode Installation
Connecting the Power Supply
Do the following to connect the main power to the Model 5570:
Note
Do not connect the power cord to the AC Mains at this time.
1.
Insert the female end of the AC power supply cable to the mains port (see
CAUTION
There are no user-serviceable parts in the power supply section
of the model SN5570. Contact Patton Electronics Technical
Support at [email protected] for more information
2.
Verify that the AC power cord included with your device is compatible with local standards. If it is not,
refer to
“Contacting Patton for Assistance”
on page 32 to find out how to replace it with a compatible
power cord.
3.
Connect the male end of the power cord to an appropriate power outlet.
Power
Figure 6. Power LED
4.
Verify that the green
Power
LED is lit (see figure 6). Blinks fast during bootloader phase and blinks slow
during boot process of Trinity Software. Becomes solid when the system is up and running.
Congratulations, you have finished installing the SmartNode Enterprise Session Border Router! Now go to
Chapter 4,