Installing the SN4120
24
SmartNode 4120 User Manual
3 • SmartNode installation
Using the included black Ethernet cable, connect the RJ-45 Ethernet WAN port on your SN4120 (labeled
ETH), to an Ethernet hub or switch on the same network as your PC.
For details on the Ethernet port pinout and cables, refer to
Appendix C, “Cabling”
on page 42 and
Appendix
D, “Port pin-outs”
on page 45.
Connecting the SN4120 to the power supply
1.
Insert the barrel-type connector end of the AC power supply into the
12V DC, 1.0A
port (see
figure 1
on
page 16).
2.
Verify that the AC power cord included with your SN4120 is compatible with local standards. If it is not,
refer to chapter 5,
“Contacting Patton for assistance”
on page 32 to find out how to replace it with a com-
patible power cord.
3.
Connect the male end of the AC power supply power cord to an appropriate AC power outlet.
4.
Verify that the green
Power
LED is lit (see
figure 2
on page 17).
Congratulations, you have finished installing the SN4120! To configure the SN4120, go to chapter 4,
“Smart-
Node initial configuration”
on page 25.
The external power supply automatically adjusts to accept an
input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
Summary of Contents for Smart Node 4120
Page 18: ...18 Chapter 2 SN4120 Applications overview Chapter contents Typical application 19...
Page 42: ...42 Appendix C Cabling Chapter contents Introduction 43 Ethernet 43 ISDN BRI 44...
Page 45: ...45 Appendix D Port pin outs Chapter contents Ethernet 46 ISDN BRI TE User port 46...
Page 47: ...47 Appendix E SN4120 factory configuration Chapter contents Introduction 48...
