OnSite OS3300 Quick Start Guide
7
3.
Connect via SSH to the extender through CPE or CO IP addresses
— Default CPE IP address: 192.168.200.10
4.
Log in with the default username
admin
and no password.
3.2 Connect with Console
1.
Connect the RS232 Console cable. (8-N-1 19200)
2.
Connect the power supply.
3.
Log in with the default username
admin
and no password.
3.3 Change the IP address (default: 192.168.200.10)
Follow the command sequence below:
node~>enable
node~#configure
node~(cfg)#context ip ROUTER
node~(ctx-ip)[router]#interface LAN
node~(if-ip)[router.LAN]#no ipaddress 192.168.200.10/24
node~(if-ip)[router.LAN]#ipaddress <new address>/<new
mask>
3.4 Change the default username
The default username will be removed once a new one is created.
Follow the command sequence below:
node~>enable
node~#configure
node~(cfg)#superuser <username> password <password>
3.5 Save the Configuration
Follow the command sequence below:
node~>enable
node~#configure
node~(cfg)#copy running-config startup-config
3.6 OnSite DSL Commands
CO and CPE:
This will set the EFM Router as CO or CPE. CO is typically used at the
network, CPE is typically used at the CPE device or CPE network.
node(prt-DSL)# mode {CO|CPE}
Annex Type:
Please consult support before changing this setting.
node~(prt-DSL)[<name>]# annex-type { b-g | a-f }
