6
OnSite OS3300 Quick Start Guide
2.4 Router/Bridge Status LEDs
The LEDs indicate the status of power, the WAN (OnSite), and Ethernet connections.
Note
When powered down, the LED indicators are clear; when powered on, the LED
indicators are yellow.
Figure 7.
OS3300 front panel
3.0 CLI Operation and Configuration
You can connect a PC to configure the OnSite 3300 using the CLI. The 3300 EFM
Router comes equipped with an password protected (easy to use) Command Line
Interface. You can connect directly to the unit and make changes immediately by using
the Console Connection or a SSH connection to the default IP address:
192.168.200.10/24. SSH is enabled by default, Telnet is disabled by default for security
reasons. In this section you can see how easy it is to change IP address, username and
save your configuration. On
page 9
you can see a sample configuration for easy con-
nections to Central EFM DSLAM or EFM Peer Router.
3.1 Connect with SSH
1.
Connect the Ethernet cable.
2.
Connect the power supply.
Table 1.
OS3300 front panel LEDs
LED Name
LED Function
Description
Power
ON
Indicates power is applied.
R
OFF
ON
WAN is configured as CO.
WAN is configured as CPE.
OnSite Pair
(one LED for each
port [1 on OS3301,
2 on OS3302, 4 on
OS3304])
OFF
ON
SLOW BLINK
FAST BLINK
Port is configured as DOWN.
Port is in data mode.
Port is in handshake mode (looking for a CPE
signal).
Port is in training mode (active communica-
tion with CPE).
Ethernet
(0/0 - 0/3)
ON
OFF
Port is linked.
Data is passing over the port.
