Patton FiberPlex 1008E, User Manual

Page: 24 / 44

Wall Mounting 24
FiberPlex 1008E User Manual 3 • Mounting Installation
Figure 17. Insert the Switch on the DIN-Rail
4.
Lightly pull down the bracket on to the rail as shown in figure 18 .
Figure 18. Stable the Switch on DIN-Rail
5.
Check if the bracket is mounted tightly on the rail.
6.
To remove the industrial Ethernet switch from the rail, do the opposite from the above steps.
Wall Mounting
Follow the steps below to mount the industrial Ethernet switch using the wall mounting bracket as shown in
figure 19 on page 25.
1. Remove the DIN-Rail bracket from the industrial Ethernet switch by loosening the screws.
2.
Place the wall mounting brackets on the top and bottom of the industrial Ethernet switch.
3.
Use the screws to screw the wall mounting bracket on the industrial Ethernet switch.