Patton FiberPlex 1008E, User Manual

Page: 19 / 44

Wiring the Power Inputs 19
FiberPlex 1008E User Manual 2 • Hardware Description
Figure 10. Remove LC Connector
2. Push down the metal clasp and pull the transceiver out by the plastic part as shown in figure 11 .
Figure 11. Pull Out from the SFP Module
Wiring the Power Inputs
Figure 12 shows the top panel of the FP1008E switch that is equipped with one 6-pin removal terminal block
connector for dual DC power inputs (12~48VDC).
Figure 12. Top Panel View of FP1008E
Do the following to insert the power wire:
1.
Insert the positive and negative wires into the PWR1 (V1+, V1-) and PWR2 (V2+, V2-) contacts on the
terminal block connector as shown in
figure 13 on page 20.