SmartNode 5400 rear panel
17
SmartNode 5400 Getting Started Guide
1 • General information
Table 3. Rear panel ports
Port
Description
WAN ETH 0/0
Auto-MDX Gigabit-Ethernet port, RJ-45 (see
figure 1
), connects the unit to an Ethernet
WAN device (for example, a cable modem, DSL modem, or fiber modem). Note:
Only full duplex modes are supported.
LAN ETH 0/1
Auto-MDX Gigabit-Ethernet port, RJ-45 (see
figure 1
), connect the unit to an Ethernet
LAN (for example, a PC, printer, or wireless bridge). Note: Only full duplex modes
are supported.
Console
Used for service and maintenance, the Console port (see
figure 1
), an RS-232 RJ-45
connector, connects the product to a serial terminal such as a PC or ASCII terminal
(also called a dumb terminal).
Reset
The reset button (see
figure 1
) has three functions:
•
Restart the unit with the current startup configuration—Press (for less than 1 second)
and release the
Reset
button to restart the unit with the current startup configuration.
•
Restart the unit with factory default configuration—Press the
Reset
button for
5 seconds until the
Power
LED (see
figure 2
on page 18) starts blinking to restart
the unit with factory default configuration.
•
Restart the unit in bootloader mode (to be used only by trained SmartNode tech-
nicians)—Starting with the unit powered off, press and hold the
Reset
button as
you apply power to the unit. Release the
Reset
button when the
Power
LED starts
blinking so the unit will enter bootloader mode.
G.SHDSL port
(option)
Provides up to 11.4 Mbps (on 4 wires) and 5.7 Mbps (on 2 wires) symmetrical
throughput, supporting ATM QoS. Supports multiple PVC and DSLAM interoperabil-
ity. The G.SHDSL LEDs are located on either side of the DSL port. ACT (when lit or
blinking) shows Activity, and LINK (when lit) shows that the DSL port is connected.