Installing the gateway router
23
SmartNode 5200 Getting Started Guide
3 • SmartNode installation
Installing cables
Connect the cables in the following order:
1.
Connect the 10/100Base-T Ethernet LAN and WAN (see section
“Connecting the 10/100Base-T Ether-
net LAN and WAN cables”
on page 23)
2.
Connect the power supply (see section
“Connecting the power supply”
on page 23)
Connecting the 10/100Base-T Ethernet LAN and WAN cables
The SmartNode 5200 has automatic MDX (auto-crossover) detection and configuration on all Ethernet ports.
Any of the ports can be connected to a host or hub/switch with a straight-through wired cable.
1.
Connect port ETH 0/0 to the subscriber port of the broadband access modem (DSL, cable, WLL).
2.
Connect Ethernet ports 1 to 4 to your LAN devices (PC, printer, switches, etc.)
For details on the Ethernet port pinout and cables, refer to
Appendix C, “Cabling”
on page 39 and
Appendix
D, “Port pin-outs”
on page 41.
Connecting the power supply
Do the following to connect the power supply to the Model 5200:
Note
Do not connect the power cord to the AC power outlet at this time.
1.
Insert the barrel-type connector end of the AC power supply into the
5V DC, 1.0A
port (see
figure 2
on
page 16).
2.
Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to
“Contacting Patton for assistance”
on page 31 to find out how to replace it with a compatible
power cord.
3.
Connect the male end of the AC power supply power cord to an appropriate AC power outlet.
Do not work on the system or connect or disconnect cables during periods of
lightning activity.
The external router power supply automatically adjusts to accept
an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
Summary of Contents for SmartNode 5200
Page 18: ...18 Chapter 2 Applications overview Chapter contents Introduction 19 Typical application 19...
Page 39: ...39 Appendix C Cabling Chapter contents Introduction 40 Ethernet 40...
Page 41: ...41 Appendix D Port pin outs Chapter contents Introduction 42 Ethernet 42...
Page 43: ...43 Appendix E SmartNode 5200 factory configuration Chapter contents Introduction 44...