Patton electronics SmartNode 4830 Series, Quick Start Manual

Page: 5 / 12

SmartNode 4830 Series Quick Start Guide 5
2. Open a Terminal connection to the SmartNode. Use the Terminal program included with most PC operat-
ing systems (e.g. Hyper Terminal on Windows).
3.
Type administrator as the login prompt and press the
Enter
key after the password prompt (do not type
anything for the password). A prompt will appear consisting of the IP address and
>
character.
login: administrator
password:
172.16.40.1>
4. Following log in, the SmartNode is in operator execution mode (indicated by
>
character in the command
line prompt). With the commands
enable
and
configure
, you enter the configuration mode.
172.16.40.1> enable
172.16.40.1# configure
172.16.40.1(cfg)#
3.3 Changing the IP address
1.
Select the context IP mode to configure an IP interface.
172.16.40.1(cfg)# context ip router
172.16.40.1(ctx-ip)[router]#
2.
Set the IP address and network mask for the each IP interface ( eth0 , for example).
Note
For the examples in this guide, a private network (172.16.1) IP address is used.
172.16.40.1(ctx-ip)[router]# interface eth0
172.16.40.1(if-ip)[eth0]# ipaddress 172.16.1.10 255.255.255.0
2002-10-29T00:09:40 : LOGINFO : Link down on interface eth0.
2002-10-29T00:09:40 : LOGINFO : Link up on interface eth0.
172.16.1.10(if-ip)[eth0]#
3. Make this modified configuration your new start-up configuration. On the next start-up the system will
initialize itself using the modified configuration.
172.16.1.10 (if-ip)[eth0]# copy running-config startup-config
172.16.1.10 (if-ip)[eth0]#